and I always thought the seals were to keep the fluid from leaking and hold the pressure.
I thought the retraction of 1mm was simply from the pressure not being applied. Damn if I could get mine to retract just a bit more then I wouldn't have to hear that dragging noise and would also reduce the frictional losses mine has. It would be a bitch to get the pads back up to temps though without that little pad/rotor contact all the time...
__________________
thanks: Aeromotive/ACL/AIM sport/Tsukigi/AP racing/APE/BDE/Big CC racing/BMC/BoostbySmith/Brembo/Calico/Carbon Lorraine/Carpenter racing/Catalyst composites/Clear alternatives/Cometic/Cosworth/CP/Cycle-tek/Dynojet/Earl's plumbing/EK/FBG/Harris/Hel/Honda/Hyperpro/Innovate/Kickstand racing/Lee Shierts racing/Lindemann Engineering/Machine pro/Magnaflow/Mikuni/NLR/NOS/Pro-bolt/Penske/Puig/R&D/RCC turbos/RCS/RPM racing/SBS/Schnitz racing/Sharkskinz/Spencer cycles/Spiegler/Sprocket specialties/Stedman/The Motorhead/Thermo-Tec/Tiger racing/TTS/Walbro/Yamaha/Yoshimura R&D/World wide bearings/Zukinot
|