Quote:
|
Check your tire pressures when you come right off the track, you're aiming for a hot pressure of 32 front 29 rear. I usually well check my pressures when the warmers are at there peak temp, but once I come off the track the pressure will go up 1 - 3 psi. Additionally you'll have to check continuously throughout the day.
To quote your "The bike should hold its line in the turn but mine wants to run wide and I'm forcing it to hold" - thats why the tire is getting ripped up, you can mess with the suspension but is there a way you can alter your riding to use it to your advantage? Turning in earlier, then getting on the gas sooner? What about trailer braking a little harder to compress the front end more to keep a steeper rake angle? When does the bike fell like it running wide, entry, mid corner, or exit? |
Quote:
Trailer braking? My trailer doesn't even have brakes :roflmao: J/K |
UPDATE:
Days 1 & 2 Shenandoah: (try to make it short)
tire warmers tire pressure 31 front, 29 rear hot all day. Ignored the first session then went out the second session and it felt terrible again. (disclaimer- there is a possibility this is all in my head and there is also a possibility that lack of skill is a contributing factor) The front end felt really light coming out of corners and was wobbling sometimes. I couldnt steer it and it would push wide hard. When I came in, I had the sag measured and the front was 46mm somehow. So we turned the preload all the way stiff and got it down to 35mm in front. It did feel better and I trusted it more and ran my best time of 26.6. The front tire looked terrible again...maybe worse than before. I'm not sure how it passed tech. It slipped once and that was it for my confidence, so I spent most of the day waiting for Glen to check the suspension. He asked if i had been at Lightning with a front like that, i hadn't been. After a little chuckle at how bad it was set up he fixed it for me, I didn't get much feedback on what he did, looked like he tightened up the dampening and compression. He said your suspension wasn't working and now it is. I went out again for 1.5 sessions but ran only 80% cause of the tire. I didn't notice anything significant...but i was more concerned with the tire. Nobody was around to mount a new one. Enjoying the process... |
UH OH....
So uhhhhh....through all of this I may have left out a minuscule detail that could hold the answer. Here's the short story...was at Beaverun...rear tire failed tech on the second day...they had no tires...except a 190 supercorsa pro. So I know a 190 tire can fit, but does it change the geometry of the bike such that one would need to adjust the suspension? Maybe it puts a little more weight on the front? Or no?
I'm also going to talk with CTR Suspensions for fun this weekend at the CCS races. |
Yes i used a 190 rear on my old 750 and it made the bike harder to turn but you could get on the gas earlier and harder when ur leaned over. It does affect the geometry since your ride height has increased.
|
Quote:
It sounds like you really need to have someone look it all over. Sometimes we get so focused on one area of the bike (forks in this case) and ignore the other end. Ifthe shock is packing in, you will have a feeling of the front end being light, it willpush wide, and it will cause head shake. All three things that you describe. |
Quote:
best of luck |
Quote:
Learned a lot about suspension along the way though. :roll: |
As stated above, give Ron at WCW a call tomorrow. Explain the situation, and where you're from...see if he can give any insight over the phone. Tell him you're with sportbikeaddicts.
|
If the bike is running wide at the exit your rear shock is squatting too much.
Add some compression to the rear shock until it feels better. You might need aftermarket suspension to get it right. |
Quote:
Or the rebound could be too slow which could also cause packing. |
Quote:
http://sportbikeaddicts.com/forums/s...25&postcount=7 |
Quote:
|
Quote:
|
All times are GMT -4. The time now is 06:38 PM. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.